ASTM A1008/A1008M-03 - 10.4.2003
 
1. Scope

1.1 This specification covers cold rolled structural, high-strength low-alloy, and high-strength low-alloy with improved formability steel sheet, in coils and cut lengths.

1.2 Cold rolled steel sheet is available in the designations as listed in 4.1.

1.3 This specification does not apply to steel strip as described in Specification A109.

1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other.

 
2. Referenced Documents

E18-25

Standard Test Methods for Rockwell Hardness of Metallic Materials

E517-24

Standard Test Method for Plastic Strain Ratio r for Sheet Metal

E646-16(2024)

Standard Test Method for Tensile Strain-Hardening Exponents (n -Values) of Metallic Sheet Materials

A941-26a

Standard Terminology Relating to Steel, Stainless Steel, Related Alloys, and Ferroalloys (Includes all amendments and changes 4/15/2026).

A109/A109M-25

Standard Specification for Steel, Strip, Carbon (0.25 Maximum Percent), Cold-Rolled

A370-26

Standard Test Methods and Definitions for Mechanical Testing of Steel Products

A568/A568M-25a

Standard Specification for Steel, Sheet, Carbon, Structural, and High-Strength Low-Alloy, Hot-Rolled and Cold-Rolled, General Requirements for (Includes all amendments and changes 12/5/2025).