1.1 This specification covers hot-rolled structural, high strength-low alloy, and high-strength low-alloy with improved formability steel sheet and strip, in coils and cut lengths. 1.2 Hot rolled steel sheet and strip is available in the designations as listed in 4.1. 1.3 This specification is not applicable to the steel covered by Specification A635/A635M. 1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. |
E18-25 | Standard Test Methods for Rockwell Hardness of Metallic Materials |
A941-26a | Standard Terminology Relating to Steel, Stainless Steel, Related Alloys, and Ferroalloys (Includes all amendments and changes 4/15/2026). |
A751-25 | Standard Test Methods and Practices for Chemical Analysis of Steel Products |
A749/A749M-26 | Standard Specification for Steel, Strip, Carbon and High-Strength, Low-Alloy, Hot-Rolled, General Requirements for |
A635/A635M-25a | Standard Specification for Steel, Sheet and Strip, Heavy-Thickness Coils, Hot-Rolled, Alloy, Carbon, Structural, High-Strength Low-Alloy, and High-Strength Low-Alloy with Improved Formability, General Requirements for (Includes all amendments and changes 12/5/2025). |
A370-26 | Standard Test Methods and Definitions for Mechanical Testing of Steel Products |
A568/A568M-25a | Standard Specification for Steel, Sheet, Carbon, Structural, and High-Strength Low-Alloy, Hot-Rolled and Cold-Rolled, General Requirements for (Includes all amendments and changes 12/5/2025). |
|