ASTM A1014/A1014M-06 - 1.3.2006
 
1. Scope

1.1 This specification covers a precipitation hardening bolting material (UNS N07718) for high temperature service.

1.2 This specification is expressed in both inch-pound and in SI units. However, unless the order specifies the applicable "M" designation (SI units), the material shall be furnished to inch-pound units.

1.3 The values stated in either inch-pounds or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

 
2. Referenced Documents

E292-24

Standard Test Methods for Conducting Time-for-Rupture Notch Tension Tests of Materials

A962/A962M-26

Standard Specification for Common Requirements for Bolting Intended for Use at Any Temperature from Cryogenic to the Creep Range

B880-24

Standard Specification for General Requirements for Chemical Check Analysis Limits for Nickel, Nickel Alloys and Cobalt Alloys

B637-26

Standard Specification for Precipitation-Hardening and Cold Worked Nickel Alloy Bars, Forgings, and Forging Stock for Moderate or High Temperature Service

Screw Threads

AS 7467

Bolts And Screws, Nickel Alloy, UNS N07718 Tensile Strength 185 KSI [1275 MPa] Stress Rupture Rated Procurement Specification

E112-25

Standard Test Methods for Determining Average Grain Size