ASTM A497/A497M-06e1 - 1.3.2006
 
1. Scope

1.1 This specification covers welded wire reinforcement made from cold-worked drawn or rolled deformed wire, or a combination of deformed and non-deformed wires, to be used for the reinforcement of concrete.

Note 1

Welded wire for concrete reinforcement has been described by various terms: welded wire fabric, WWF, fabric, and mesh. The wire reinforcement industry prefers the term "welded wire reinforcement" (WWF) as being more representative of the range of products being manufactured. Therefore, the term "welded wire fabric" has been replaced with the term "welded wire reinforcement" in this specifcation and in other related specifications.

1.2 The values stated in either inch-pound or SI units are to be regarded as the standard. Within the text the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values may result in nonconformance with the specification.

 
2. Referenced Documents

Testing Jig Drawing Available from ASTM International Headquarters. Order Adjunct No. . Original adjunct produced in 1967.

A700-14(2019)

Standard Guide for Packaging, Marking, and Loading Methods for Steel Products for Shipment

Fed. Std. No. 123

Marking for Shipments (Civil Agencies)

A82-A82M-07

Standard Specification for Steel Wire, Plain, for Concrete Reinforcement (Withdrawn 2013)

A496-A496M-07

Standard Specification for Steel Wire, Deformed, for Concrete Reinforcement (Withdrawn 2013)

MIL-STD-129

Marking for Shipment and Storage Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098, http://www.dodssp.daps.mil.