ASTM A705/A705M-13 - 1.5.2013
 
1. Scope

1.1 This specification2 covers age-hardening stainless steel forgings for general use.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 Unless the order specifies an “M” designation, the material shall be furnished to inch-pound units.

Note 1—Bar products are covered by Specification A564/A564M.
 
2. Referenced Documents

A370-26

Standard Test Methods and Definitions for Mechanical Testing of Steel Products

A484/A484M-24b

Standard Specification for General Requirements for Stainless Steel Bars, Billets, Shapes, and Forgings (Includes all amendments and changes 9/5/2024).

SAE J?1086

Recommended Practice for Numbering Metals and Alloys (UNS)

A751-25

Standard Test Methods and Practices for Chemical Analysis of Steel Products

E527-23

Standard Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)

A564/A564M-25

Standard Specification for Hot-Rolled and Cold-Finished Age-Hardening Stainless Steel Bars and Shapes