1.1 This specification covers stainless steel floor plates ½ in. and under for use in galley spaces, washrooms, engine rooms, and machinery spaces, and for ladder treads, gun platforms, and deck treads. For these uses, Patterns A, B, and C are considered interchangeable (see Fig. 1, Fig. 2, and Fig. 3). 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
FIG. 1 Pattern A (percent of reduction, 61 %)
FIG. 2 Pattern B (original of raised figures approximately 1¼ in., percent of reduction 61 %)
FIG. 3 Pattern C
|
A370-26 | Standard Test Methods and Definitions for Mechanical Testing of Steel Products |
A340-23a | Standard Terminology of Symbols and Definitions Relating to Magnetic Testing (Includes all amendments and changes 12/19/2023). |
A480/A480M-25b | Standard Specification for General Requirements for Flat-Rolled Stainless and Heat-Resisting Steel Plate, Sheet, and Strip (Includes all amendments and changes 9/10/2025). |
A700-14(2019) | Standard Guide for Packaging, Marking, and Loading Methods for Steel Products for Shipment |
MIL-I-17214 | Indicator, Permeability; Low Mu (Go-NoGo) Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098, http://www.dodssp.daps.mil. |
MIL-STD-163 | Preservation of Steel Products for Domestic Shipment (Storage and Overseas Shipment) |
|