1.1 This specification covers requirements for a high strength drawn and cold rolled steel wire in two strength classes, with rectangular cross section, and round mill edge. This wire is intended for prestressed vessel and press frame windings. 1.2 The values stated in either inch-pound units or SI (metric) units are to be regarded separately as standards. Within the text and tables, the SI units are shown in parentheses. The values stated in each system are not exact equivalents. Therefore, each system must be used independent of the other. Combining values from the two systems may result in nonconformance with the specification. |
Fed. Std. No. 123 | Marking for Shipment (Civil Agencies) 6 |
A510-08 | Standard Specification for General Requirements for Wire Rods and Coarse Round Wire, Carbon Steel |
A370-26 | Standard Test Methods and Definitions for Mechanical Testing of Steel Products |
AIAGB-5 | 02.00 Primary Metals Identification Tag Application Standard Available from Automotive Industry Action Group (AIAG), 26200 Lahser Rd., Suite 200, Southfield, MI 48034. |
A700-14(2019) | Standard Guide for Packaging, Marking, and Loading Methods for Steel Products for Shipment |
E30-89 | Test Methods for Chemical Analysis of Steel, Cast Iron, Open-Hearth Iron, and Wrought Iron (Withdrawn 1995) |
E309-24 | Standard Practice for Eddy Current Examination of Steel Tubular Products |
A510M-08 | Standard Specification for General Requirements for Wire Rods and Coarse Round Wire, Carbon Steel [Metric] (Withdrawn 2011) |
MIL-STD-163 | Steel Mill Products, Preparation for Shipment and Storage Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098 |
|