ASTM A905-19 - 1.9.2019
 
1. Scope

1.1 This specification covers requirements for a high strength drawn and cold rolled steel wire in two strength classes, with rectangular cross section, and round mill edge. This wire is intended for prestressed vessel and press frame windings.

1.2 The values stated in either inch-pound units or SI (metric) units are to be regarded separately as standards. Within the text and tables, the SI units are shown in parentheses. The values stated in each system are not exact equivalents. Therefore, each system must be used independent of the other. Combining values from the two systems may result in nonconformance with the specification.

1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

 
2. Referenced Documents

Fed. Std. No. 123

Marking for Shipment (Civil Agencies) 6

A510-08

Standard Specification for General Requirements for Wire Rods and Coarse Round Wire, Carbon Steel

A370-23

Standard Test Methods and Definitions for Mechanical Testing of Steel Products

AIAGB-5

02.00 Primary Metals Identification Tag Application Standard Available from Automotive Industry Action Group (AIAG), 26200 Lahser Rd., Suite 200, Southfield, MI 48034.

A700-14(2019)

Standard Guide for Packaging, Marking, and Loading Methods for Steel Products for Shipment

E30-89

Test Methods for Chemical Analysis of Steel, Cast Iron, Open-Hearth Iron, and Wrought Iron (Withdrawn 1995)

E309-16

Standard Practice for Eddy Current Examination of Steel Tubular Products Using Magnetic Saturation

A510M-08

Standard Specification for General Requirements for Wire Rods and Coarse Round Wire, Carbon Steel [Metric] (Withdrawn 2011)

MIL-STD-163

Steel Mill Products, Preparation for Shipment and Storage Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098