ASTM B151/B151M-13 - 1.10.2013
 
1. Scope

1.1 This specification establishes the requirements for copper-nickel-zinc and copper-nickel rod and bar for general application produced from Copper Alloy UNS Nos. C70600, C70620, C71500, C71520, C74500, C75200, C75700, C76400, C77000, and C79200.

1.1.1 Copper Alloys UNS Nos. C70620 and C71520 are for product intended for welding applications.

1.1.2 Units—The values stated in either inch-pound or SI units are to be regarded separately as standard. Within the text, SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

Note 1—Requirements for copper-nickel-zinc alloy wire appear in Specification B206/B206M.
 
2. Referenced Documents

B249/B249M-23

Standard Specification for General Requirements for Wrought Copper and Copper-Alloy Rod, Bar, Shapes and Forgings

B950-26

Standard Guide for Editorial Procedures and Form of Product Specifications for Copper and Copper Alloys

B846-24

Standard Terminology for Copper and Copper Alloys

B601-24

Standard Classification for Temper Designations for Copper and Copper Alloys—Wrought and Cast

B206/B206M-12(2024)

Standard Specification for Copper-Nickel-Zinc (Nickel Silver) Wire and Copper-Nickel Alloy Wire

E478-24

Standard Test Methods for Chemical Analysis of Copper Alloys

E76-88(1998)

Standard Test Methods for Chemical Analysis of Nickel-Copper Alloys (Withdrawn 2003)

E75-76(1996)

Standard Test Methods for Chemical Analysis of Copper-Nickel and Copper-Nickel-Zinc Alloys