ASTM B19-01 - 10.4.2001
 
1. Scope

1.1 This specification establishes the requirements for sheet, strip, plate, bar, and disks for the manufacture of ammunition of component parts thereof from alloy UNS C26000.

1.2 Values given in inch-pound units are the standard except for grain size which is stated in metric units. SI values given in parenthesis are for information only.

1.3 The following safety caveat pertains only to the test method described in Section 10 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

B601-24

Standard Classification for Temper Designations for Copper and Copper Alloys—Wrought and Cast

B846-24

Standard Terminology for Copper and Copper Alloys

B858-06(2024)

Standard Test Method for Ammonia Vapor Test for Determining Susceptibility to Stress Corrosion Cracking in Copper Alloys

B900-16(2022)

Standard Practice for Packaging of Copper and Copper Alloy Mill Products for U.S. Government Agencies

E3-26

Standard Guide for Preparation of Metallographic Specimens

E8/E8M-25

Standard Test Methods for Tension Testing of Metallic Materials

E29-22

Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

E112-25e1

Standard Test Methods for Determining Average Grain Size (Includes all amendments and changes 9/9/2026).

B154-16(2022)

Standard Test Method for Mercurous Nitrate Test for Copper Alloys

B248-22

Standard Specification for General Requirements for Wrought Copper and Copper-Alloy Plate, Sheet, Strip, and Rolled Bar

E255-23

Standard Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition

E478-24

Standard Test Methods for Chemical Analysis of Copper Alloys

E527-23

Standard Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)