ASTM B233-97(2007)

ASTM B233-97(2007) - 1.10.2007

1. Scope

1.1 This specification covers aluminum 1350 drawing stock 0.375 in. (9.52 mm) to 1.000 in. (25.40 mm) in diameter, in the tempers shown in , for drawing into wire for electrical conductors (Explanatory Note 1 and Note 2).

1.2 The SI values of density and resistivity are to be regarded as the standard. For all other properties the inch-pound values are to be regarded as standard and the SI units may be approximate.

Note 1

Prior to 1975, aluminum 1350 was designated as EC aluminum.

Note 2

The aluminum and temper designations conform to ANSI H35.1. Aluminum 1350 corresponds to unified numbering system A91350 in accordance with Practice E 527.

2. Referenced Documents

NBS Handbook 100	Copper Wire Tables
E527-23	Standard Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)
E227-90(1996)	Standard Test Method for Optical Emission Spectrometric Analysis of Aluminum and Aluminum Alloys by the Point-to-Plane Technique (Withdrawn 2002)
E55-23	Standard Practice for Sampling Wrought Nonferrous Metals and Alloys for Determination of Chemical Composition
E34-11	Standard Test Methods for Chemical Analysis of Aluminum and Aluminum-Base Alloys
B830-18(2026)	Standard Specification for Uniform Test Methods and Frequency
B557-15(2023)	Standard Test Methods for Tension Testing Wrought and Cast Aluminum- and Magnesium-Alloy Products
B354-23	Standard Terminology Relating to Uninsulated Metallic Electrical Conductors
B193-25	Standard Test Method for Resistivity of Electrical Conductor Materials