ASTM D3368-17(2022) - 15.3.2022
 
1. Scope

1.1?This specification covers unfilled, unpigmented FEP resin sheet and film less than 3.175 mm (0.125 in.) thick. Recycled materials are allowed in accordance with 6.2.

1.2?The values stated in SI units as detailed in IEEE/ASTM SI 10 are to be regarded as standard and the practices of IEEE/ASTM SI 10 incorporated herein.

1.3?The following safety hazards caveat pertains only to the test methods portion, Section 14, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

Note 1:?There is no known ISO equivalent to this standard.

1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

 
2. Referenced Documents

D5740-18

Standard Guide for Writing Material Standards in the Classification D4000 Format

E691-23

Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method

IEEE/ASTM SI 10

Standard for Use of the International System of Units (SI)

D149-20

Standard Test Method for Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating Materials at Commercial Power Frequencies

TAPPI 411

Standard Thickness (Caliper) of Paper and Paper Products Available from Technical Association of the Pulp and Paper Industry (TAPPI), 15 Technology Parkway South, Norcross, GA 30092, http://www.tappi.org.

D374-99

Standard Test Methods for Thickness of Solid Electrical Insulation

D618-21

Standard Practice for Conditioning Plastics for Testing

D638-22

Standard Test Method for Tensile Properties of Plastics

D792-20

Standard Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement

D882-18

Standard Test Method for Tensile Properties of Thin Plastic Sheeting

D883-24

Standard Terminology Relating to Plastics

D2116-16(2021)

Standard Specification for FEP Resin Molding and Extrusion Materials

D3892-15(2020)

Standard Practice for Packaging/Packing of Plastics