ASTM D4619-96 - 1.1.1996
 
1. Scope

1.1 This practice describes procedures for conducting inspections of the conditions of various linings in operating Flue Gas Desulfurization (FGD) system components.

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 7.

 
2. Referenced Documents

D610-25

Standard Practice for Evaluating Degree of Rusting on Painted Steel Surfaces

SSPC-VIS 2

Standard Method of Evaluating Degree of Rusting on Painted Steel Surfaces

D714-25

Standard Test Method for Evaluating Degree of Blistering of Paints

D7091-22

Standard Practice for Nondestructive Measurement of Dry Film Thickness of Nonmagnetic Coatings Applied to Ferrous Metals and Nonmagnetic, Nonconductive Coatings Applied to Non-Ferrous Metals

D2240-15(2021)

Standard Test Method for Rubber Property—Durometer Hardness

D6677-18(2022)

Standard Test Method for Evaluating Adhesion by Knife

C805-02

Standard Test Method for Rebound Number of Hardened Concrete

D4541-22

Standard Test Method for Pull-Off Strength of Coatings Using Portable Adhesion Testers

C856-18

Standard Practice for Petrographic Examination of Hardened Concrete