ASTM D4857-01a - 10.11.2001
 
1. Scope

1.1 This test method evaluates the performance of lubricants intended for use in two-stroke-cycle spark-ignition gasoline engines which are particularly prone to ring sticking. Piston varnish and spark plug fouling are also evaluated.

1.2 The values stated in SI units are the standard. The values given in parentheses are provided for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

D4859-13

Standard Specification for Lubricants for Two-Stroke-Cycle Spark-Ignition Gasoline Engines-TC (Withdrawn 2022)

ANSI MC 96.1

American National Standard for Temperature Measurement Thermocouples Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036.

D445-26

Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity)

D874-23

Standard Test Method for Sulfated Ash from Lubricating Oils and Additives

D2270-24

Standard Practice for Calculating Viscosity Index from Kinematic Viscosity at 40 ?C and 100 ?C

D2622-26

Standard Test Method for Sulfur in Petroleum Products by Wavelength Dispersive X-ray Fluorescence Spectrometry

D4052-22

Standard Test Method for Density, Relative Density, and API Gravity of Liquids by Digital Density Meter

D4629-24

Standard Test Method for Trace Nitrogen in Liquid Hydrocarbons by Syringe/Inlet Oxidative Combustion and Chemiluminescence Detection

D4858-13

Standard Test Method for Determination of the Tendency of Lubricants to Promote Preignition in Two-Stroke-Cycle Gasoline Engines (Withdrawn 2022)

D4863-13

Standard Test Method for Determination of Lubricity of Two-Stroke-Cycle Gasoline Engine Lubricants (Withdrawn 2022)

D4951-14(2019)

Standard Test Method for Determination of Additive Elements in Lubricating Oils by Inductively Coupled Plasma Atomic Emission Spectrometry

E230-03

Standard Specification and Temperature-Electromotive Force (EMF) Tables for Standardized Thermocouples

D235-22

Standard Specification for Mineral Spirits (Petroleum Spirits) (Hydrocarbon Dry Cleaning Solvent)

B152/B152M-24

Standard Specification for Copper Sheet, Strip, Plate, and Rolled Bar

D93-26

Standard Test Methods for Flash Point by Pensky-Martens Closed Cup Tester

G40-25a

Standard Terminology Relating to Wear and Erosion (Includes all amendments and changes 12/8/2025).