ASTM D5147-07 - 15.1.2007
 
1. Scope

1.1 These test methods cover procedures for sampling and testing prefabricated, reinforced, polymer-modified bituminous sheet materials designed for single- or multiple-ply application in roofing and waterproofing membranes. These products may use various surfacing materials on one side.

1.2 These test methods appear in the following order:

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

D95-23e1

Standard Test Method for Water in Petroleum Products and Bituminous Materials by Distillation (Includes all amendments and changes 10/25/2024).

E691-23

Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method

E177-26a

Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods (Includes all amendments and changes 5/14/2026).

D5869-07

Standard Practice for Dark Oven Heat Exposure of Roofing and Waterproofing Materials

D146-04

Standard Test Methods for Sampling and Testing Bitumen-Saturated Felts and Woven Fabrics for Roofing and Waterproofing

D4977-03

Standard Test Method for Granule Adhesion to Mineral Surfaced Roofing by Abrasion

D4073-06

Standard Test Method for Tensile-Tear Strength of Bituminuous Roofing Membranes

D1204-25

Standard Test Method for Linear Dimensional Changes of Nonrigid Thermoplastic Sheeting or Film at Elevated Temperature

D4798-08

Standard Practice for Accelerated Weathering Test Conditions and Procedures for Bituminous Materials (Xenon-Arc Method)

D5636-94(1999)e1

Standard Test Method for Low Temperature Unrolling of Felt or Sheet Roofing and Waterproofing Materials