ASTM D5213-19 - 1.3.2019
 
1. Scope

1.1 This specification covers requirements for the material, dimensions and tolerances, and property values of film, in sheet or strip form, with or without heat-sealable coatings.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

Note 1: This document is similar to IEC 60674, Part 3, Sheets 2, 4, 5, 6, and 7.

1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

 
2. Referenced Documents

D1711-25a

Standard Terminology Relating to Electrical Insulation (Includes all amendments and changes 12/12/2025).

D3636-24

Standard Practice for Sampling and Judging Quality of Solid Electrical Insulating Materials

D2305-18

Standard Test Methods for Polymeric Films Used for Electrical Insulation

D4088-82(1997)

Standard Practice for Preparation for Shipment of Solid Electrical Insulating Materials (Withdrawn 2003)

D883-26

Standard Terminology Relating to Plastics

D149-25

Standard Test Method for Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating Materials at Commercial Power Frequencies

Publication 60674-3

Specification for Electrical Films for Electrical Purposes Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org.