ASTM D5813-04 - 1.3.2004
 
1. Scope

1.1 This specification covers cured-in-place thermosetting resin pipe (CIPP), 4 through 132-in. (100 through 3353-mm) equivalent diameter, for use in gravity flow systems for conveying sanitary sewage, storm water, and certain industrial wastes. This specification is suited for the evaluation and testing of materials used in the rehabilitation of existing pipes by the installation and cure of a resin-impregnated fabric liner.

1.2 This specification can also be extended to cover manholes, pump stations, wetwells, vaults, storage tanks, and other similar structures where a cured in place liner using thermosetting resin is applicable.

1.3 The values given in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

Note 1—There are no ISO standards covering the primary subject matter of this specification.

1.4 The following safety hazards caveat pertains only to the test methods portion, Section , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

D638-22

Standard Test Method for Tensile Properties of Plastics

D695-26

Standard Test Method for Compressive Properties of Rigid Plastics

D790-25

Standard Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials

D883-26b

Standard Terminology Relating to Plastics (Includes all amendments and changes 8/24/2026).

D543-21

Standard Practices for Evaluating the Resistance of Plastics to Chemical Reagents

D1600-18

Standard Terminology for Abbreviated Terms Relating to Plastics (Withdrawn 2024)

Methods of Test for Breaking Load and Elongation of Textile Fabrics Withdrawn. The last approved version of this historical standard is referenced on www.astm.org.

D3039/D3039M-17(2025)

Standard Test Method for Tensile Properties of Polymer Matrix Composite Materials

D3567-17(2022)

Standard Practice for Determining Dimensions of “Fiberglass” (Glass-Fiber-Reinforced Thermosetting Resin) Pipe and Fittings

D3681-23

Standard Test Method for Chemical Resistance of “Fiberglass” (Glass–Fiber–Reinforced Thermosetting-Resin) Pipe in a Deflected Condition

F2019-22

Standard Practice for Rehabilitation of Existing Pipelines and Conduits by the Pulled in Place Installation of Glass Reinforced Plastic Cured-in-Place (GRP-CIPP) Using the UV-Light Curing Method

D4814-26

Standard Specification for Automotive Spark-Ignition Engine Fuel

F412-25a

Standard Terminology Relating to Plastic Piping Systems (Includes all amendments and changes 10/8/2025).

F1216-24a

Standard Practice for Rehabilitation of Existing Pipelines and Conduits by the Inversion and Curing of a Resin-Impregnated Tube (Includes all amendments and changes 11/12/2024).

F1743-25

Standard Practice for Rehabilitation of Existing Pipelines and Conduits by Pulled-in-Place Installation of Cured-in-Place Thermosetting Resin Pipe (CIPP)