ASTM D6114-97e1 - 25.9.1998
 
1. Scope

1.1 This specification covers asphalt-rubber binder, consisting of a blend of paving grade asphalt cements, ground recycled tire (that is, vulcanized) rubber and other additives, as needed, for use as binder in pavement construction. The rubber shall be blended and interacted in the hot asphalt cement sufficiently to cause swelling of the rubber particles prior to use.

 
2. Referenced Documents

D5644-23

Standard Test Method for Rubber Compounding Materials—Determination of Particle Size Distribution of Recycled Vulcanizate Particulate Rubber

D5329-20

Standard Test Methods for Sealants and Fillers, Hot-Applied, for Joints and Cracks in Asphalt Pavements and Portland Cement Concrete Pavements

D3381-09

Standard Specification for Viscosity-Graded Asphalt Cement for Use in Pavement Construction

D2872-22

Standard Test Method for Effect of Heat and Air on a Moving Film of Asphalt Binder (Rolling Thin-Film Oven Test)

D2196-20(2026)

Standard Test Methods for Rheological Properties of Non-Newtonian Materials by Rotational Viscometer

D5-06

Standard Test Method for Penetration of Bituminous Materials

D1754-97

Standard Test Method for Effect of Heat and Air on Asphaltic Materials (Thin-Film Oven Test)

D946-09

Standard Specification for Penetration-Graded Asphalt Cement for Use in Pavement Construction

D140-01

Standard Practice for Sampling Bituminous Materials

D93-26

Standard Test Methods for Flash Point by Pensky-Martens Closed Cup Tester

D36-06

Standard Test Method for Softening Point of Bitumen (Ring-and-Ball Apparatus)

D1864-89(1999)e1

Standard Test Method for Moisture in Mineral Aggregate Used on Built-Up Roofs