ASTM D6622-01 - 10.1.2001
 
1. Scope

1.1 This guide covers the minimum installation recommendations for fully adhered, hot-applied reinforced waterproofing systems on vertical and low-slope (plaza deck) surfaces.

1.2 For the purpose of this guide, the substrate is assumed to be concrete or masonry, structurally sound, able to accept the weight of anticipated loads, and meets the local building code requirements. Similarly, all components of the waterproofing system are assumed to comply with any federal, state, and local environmental regulations that may be in effect at the time of installation. Expansion joints, insulation, drainage layers, and overburden are beyond the scope of this guide.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

 
2. Referenced Documents

D1668-97a

Standard Specification for Glass Fabrics (Woven and Treated) for Roofing and Waterproofing

D2178-04

Standard Specification for Asphalt Glass Felt Used in Roofing and Waterproofing (Withdrawn 2013)

D2822-05

Standard Specification for Asphalt Roof Cement, Asbestos Containing

D4022-07

Standard Specification for Coal Tar Roof Cement, Asbestos Containing

D4586-07

Standard Specification for Asphalt Roof Cement, Asbestos-Free

D4990-97a(2020)

Standard Specification for Coal-Tar Glass Felt Used in Roofing and Waterproofing (Includes all amendments and changes 5/15/2020).

D6506-01

Standard Specification for Asphalt Based Protection for Below-Grade Waterproofing

D5643-06

Standard Specification for Coal Tar Roof Cement, Asbestos Free

D5726-98(2020)

Standard Specification for Thermoplastic Fabrics Used in Hot-Applied Roofing and Waterproofing

D5898-96

Standard Guide for Standard Details for Adhered Sheet Waterproofing

D5957-98(2021)

Standard Guide for Flood Testing Horizontal Waterproofing Installations

D6152-99

Standard Specification for SEBS-Modified Mopping Asphalt Used in Roofing

D6162-00a

Standard Specification for Styrene Butadiene Styrene (SBS) Modified Bituminous Sheet Materials Using a Combination of Polyester and Glass Fiber Reinforcements

D6163-00e1

Standard Specification for Styrene Butadiene Styrene (SBS) Modified Bituminous Sheet Materials Using Glass Fiber Reinforcements

D6164-05

Standard Specification for Styrene Butadiene Styrene (SBS) Modified Bituminous Sheet Materials Using Polyester Reinforcements

CAN/CGSB-37.51

Application for Hot-Applied Rubberized Asphalt for Roofing and Waterproofing

C981-20

Standard Guide for Design of Built-Up Bituminous Membrane Waterproofing Systems for Building Decks

D41-05

Standard Specification for Asphalt Primer Used in Roofing, Dampproofing, and Waterproofing

D43-00

Standard Specification for Coal Tar Primer Used in Roofing, Dampproofing, and Waterproofing

D173-03

Standard Specification for Bitumen-Saturated Cotton Fabrics Used in Roofing and Waterproofing

D226-06

Standard Specification for Asphalt-Saturated Organic Felt Used in Roofing and Waterproofing

D6451-99

Standard Guide for Application of Asphalt Based Protection Board

D1327-04

Standard Specification for Bitumen-Saturated Woven Burlap Fabrics Used in Roofing and Waterproofing

D1079-26b

Standard Terminology Relating to Roofing and Waterproofing (Includes all amendments and changes 5/18/2026).

D450-07

Standard Specification for Coal-Tar Pitch Used in Roofing, Dampproofing, and Waterproofing

D449-03

Standard Specification for Asphalt Used in Dampproofing and Waterproofing

D227-03

Standard Specification for Coal-Tar-Saturated Organic Felt Used in Roofing and Waterproofing

D5295-00

Standard Guide for Preparation of Concrete Surfaces for Adhered (Bonded) Membrane Waterproofing Systems