ASTM D6694-01 - 10.7.2001
 
1. Scope

1.1 This specification covers a liquid-applied solvent dispersed elastomeric coating used as a roofing membrane for spray polyurethane foam (SPF) insulation whose principal polymer in the dispersion contains more than 95 % silicone.

1.2 This specification does not provide guidance for application.

1.3 The following precautionary caveat pertains only to the test method portions, Sections 5 and 6.

1.4 SI units are used throughout this document. Inch-pound units are in parentheses.

This standard may involve hazardous materials, operations, and equipment.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

 
2. Referenced Documents

D2196-20(2026)

Standard Test Methods for Rheological Properties of Non-Newtonian Materials by Rotational Viscometer

D2370-16(2021)

Standard Test Method for Tensile Properties of Organic Coatings

E96/E96M-24a

Standard Test Methods for Gravimetric Determination of Water Vapor Transmission Rate of Materials (Includes all amendments and changes 11/20/2024).

D16-1989

Suggested Procedure for Development of Spill Prevention Control and Countermeasure (SPCC) Plans - (To Assist Conformance to Requirements of Title 40, Code of Federal Regulations, Part 112)

D2697-22

Standard Test Method for Volume Nonvolatile Matter in Clear or Pigmented Coatings

D1644-01(2023)

Standard Test Methods for Nonvolatile Content of Varnishes

D522-93a(2001)

Standard Test Methods for Mandrel Bend Test of Attached Organic Coatings

D624-00(2020)

Standard Test Method for Tear Strength of Conventional Vulcanized Rubber and Thermoplastic Elastomers

D903-98(2025)

Standard Test Method for Peel or Stripping Strength of Adhesive Bonds

D1079-26b

Standard Terminology Relating to Roofing and Waterproofing (Includes all amendments and changes 5/18/2026).

D4798-08

Standard Practice for Accelerated Weathering Test Conditions and Procedures for Bituminous Materials (Xenon-Arc Method)