ASTM D6947-07(2013) - 1.5.2013
 
1. Scope

1.1 This specification covers a single component, moisture cured, elastomeric urethane polymer coating used as a protective coating for spray polyurethane foam roofing systems.

1.2 This specification does not provide guidance for application.

1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.4 The following precautionary caveat pertains only to the test method portions, Sections 5 and 6.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

 
2. Referenced Documents

D16-1989

Suggested Procedure for Development of Spill Prevention Control and Countermeasure (SPCC) Plans - (To Assist Conformance to Requirements of Title 40, Code of Federal Regulations, Part 112)

D1653-13(2021)

Standard Test Methods for Water Vapor Transmission of Organic Coating Films

D2196-20(2026)

Standard Test Methods for Rheological Properties of Non-Newtonian Materials by Rotational Viscometer

D2697-22

Standard Test Method for Volume Nonvolatile Matter in Clear or Pigmented Coatings

D2370-16(2021)

Standard Test Method for Tensile Properties of Organic Coatings

D4798-08

Standard Practice for Accelerated Weathering Test Conditions and Procedures for Bituminous Materials (Xenon-Arc Method)

G21-15(2021)e1

Standard Practice for Determining Resistance of Synthetic Polymeric Materials to Fungi (Includes all amendments and changes 6/22/2021).

D1644-01(2023)

Standard Test Methods for Nonvolatile Content of Varnishes

D471-16a(2021)

Standard Test Method for Rubber Property—Effect of Liquids (Includes all amendments and changes 6/25/2021).

D522-93a(2001)

Standard Test Methods for Mandrel Bend Test of Attached Organic Coatings

D562-10(2023)

Standard Test Method for Consistency of Paints Measuring Krebs Unit (KU) Viscosity Using a Stormer-Type Viscometer

D412-16(2021)

Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers—Tension

D624-00(2020)

Standard Test Method for Tear Strength of Conventional Vulcanized Rubber and Thermoplastic Elastomers

D903-98(2025)

Standard Test Method for Peel or Stripping Strength of Adhesive Bonds

D1079-26b

Standard Terminology Relating to Roofing and Waterproofing (Includes all amendments and changes 5/18/2026).