ASTM D704-99(2020) - 1.12.2020
 
1. Scope

1.1?This specification covers compression molding, thermosetting, melamine-formaldehyde molding compounds as further defined in 4.1, resin binder, with or without other resins, intimately combined with fillers, pigments, and any chemical agents needed.

1.2?The values stated in SI units are to be regarded as the standard.

Note 1:?The properties included in this specification are those required to identify the types of molding compounds covered. There may be other requirements necessary to identify particular characteristics. These will be added to the specification as their inclusion becomes generally desirable and the necessary test data and methods become available. Transfer or injection molding will usually result in different physical and electrical characteristics than compression molding.

Note 2:?ISO 2122-1977(E) is similar but not equivalent to this specification. Product classification and characterization are not equivalent.

1.3?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

 
2. Referenced Documents

D3638-21e1

Standard Test Method for Comparative Tracking Index of Electrical Insulating Materials (Includes all amendments and changes 2/2/2022).

D3892-15(2020)

Standard Practice for Packaging/Packing of Plastics

D495-22

Standard Test Method for High-Voltage, Low-Current, Dry Arc Resistance of Solid Electrical Insulation

D570-22

Standard Test Method for Water Absorption of Plastics

D618-21

Standard Practice for Conditioning Plastics for Testing

D648-18

Standard Test Method for Deflection Temperature of Plastics Under Flexural Load in the Edgewise Position

D731-22

Standard Test Method for Molding Index of Thermosetting Molding Powder

D790-25

Standard Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials

D792-20

Standard Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement

D883-26

Standard Terminology Relating to Plastics

D1895-24

Standard Test Methods for Apparent Density, Bulk Factor, and Pourability of Plastic Materials

D1896-09

Standard Practice for Transfer Molding Test Specimens of Thermosetting Compounds

D149-25

Standard Test Method for Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating Materials at Commercial Power Frequencies

D150-22

Standard Test Methods for AC Loss Characteristics and Permittivity (Dielectric Constant) of Solid Electrical Insulation

D256-26

Standard Test Methods for Determining the Izod Pendulum Impact Resistance of Plastics

D3795-20

Standard Test Method for Thermal Flow, Cure, and Behavior Properties of Pourable Thermosetting Materials by Torque Rheometer

Manual 7

Manual on Presentation of Data and Control Chart Analysis, 8th Edition Available from ASTM International Headquarters. Request MNL7-8TH.

D5224-12(2019)

Standard Practice for Compression Molding Test Specimens of Thermosetting Molding Compounds

D6289-13(2019)

Standard Test Method for Measuring Shrinkage from Mold Dimensions of Molded Thermosetting Plastics

ISO 2122-1977(E)

Plastics--Aminoplastic Molding Materials--Specification Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org.