ASTM D7492/D7492M-11 - 15.11.2011
 
Significance and Use

This guide provides information and guidelines for the selection and installation of drainage systems media that are in conjunction with waterproofing systems. This guide is intended to be used in conjunction with Guides C898, C981, C1471, D5898, and D6622 and to provide guidelines for the total waterproofing and drainage system.

 
1. Scope

1.1 This guide makes recommendations for the selection and application of prefabricated drainage media used in conjunction with waterproofing systems on horizontal and vertical surfaces. Drainage media considered include rigid and semi-rigid insulation boards and rigid materials including plastics. The scope of this guide does not cover other drainage media including gravel and filter fabric systems that can be constructed. The scope of this guide does not cover drainage materials or drainage system designs used for vegetative roof systems. Vegetative roof systems require specialized designs.

1.2 The committee with jurisdiction over this standard is not aware of any other comparable standards published by other organizations.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4 This standard may involve hazardous materials, operations and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

C1471/C1471M-22

Standard Guide for the Use of High Solids Content Cold Liquid-Applied Elastomeric Waterproofing Membrane on Vertical Surfaces

D2434-26

Standard Test Methods for Laboratory Measurement of Hydraulic Conductivity of Coarse-Grained Soils

D5898/D5898M-96(2021)

Standard Guide for Standard Details for Adhered Sheet Waterproofing

D4716/D4716M-22

Standard Test Method for Determining the (In-plane) Flow Rate per Unit Width and Hydraulic Transmissivity of a Geosynthetic Using a Constant Head

D4511-11(2020)

Standard Test Method for Hydraulic Conductivity of Essentially Saturated Peat

D3273-21

Standard Test Method for Resistance to Growth of Mold on the Surface of Interior Coatings in an Environmental Chamber

D6622-01

Standard Guide for Application of Fully Adhered Hot-Applied Reinforced Waterproofing Systems

C981-20

Standard Guide for Design of Built-Up Bituminous Membrane Waterproofing Systems for Building Decks

E154/E154M-08a(2025)

Standard Test Methods for Water Vapor Retarders Used in Contact with Earth Under Concrete Slabs, on Walls, or as Ground Cover (Includes all amendments and changes 2/14/2025).

C898/C898M-25a

Standard Guide for Use of High Solids Content, Cold Liquid-Applied Elastomeric Waterproofing Membrane with Separate Wearing Course (Includes all amendments and changes 12/3/2025).

C165-23

Standard Test Method for Measuring Compressive Properties of Thermal Insulations

D896-04(2025)

Standard Practice for Resistance of Adhesive Bonds to Chemical Reagents

D1079-26b

Standard Terminology Relating to Roofing and Waterproofing (Includes all amendments and changes 5/18/2026).

D3385-18

Standard Test Method for Infiltration Rate of Soils in Field Using Double-Ring Infiltrometer

D4630-19

Standard Test Method for Determining Transmissivity and Storage Coefficient of Low-Permeability Rocks by In Situ Measurements Using the Constant Head Injection Test