ASTM F1295-22 - 15.11.2022
 
1. Scope

1.1?This specification covers the chemical, mechanical, and metallurgical requirements for wrought annealed, cold-worked, or hot-worked titanium-6aluminum-7niobium alloy bar, wire, sheet, strip, and plate to be used in the manufacture of surgical implants (1-7).2

1.2?The SI units in this standard are the primary units. The values stated in either primary SI units or secondary inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.3?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

 
2. Referenced Documents

E290-22

Standard Test Methods for Bend Testing of Material for Ductility

E1409-13(2021)

Standard Test Method for Determination of Oxygen and Nitrogen in Titanium and Titanium Alloys by Inert Gas Fusion

E1447-22

Standard Test Method for Determination of Hydrogen in Reactive Metals and Reactive Metal Alloys by Inert Gas Fusion with Detection by Thermal Conductivity or Infrared Spectrometry

E2371-21a

Standard Test Method for Analysis of Titanium and Titanium Alloys by Direct Current Plasma and Inductively Coupled Plasma Atomic Emission Spectrometry (Performance-Based Test Methodology) (Includes all amendments and changes 1/6/2022).

E1941-10(2016)

Standard Test Method for Determination of Carbon in Refractory and Reactive Metals and Their Alloys by Combustion Analysis

IEEE/ASTM SI 10

American National Standard for Use of the International System of Units (SI): The Modern Metric System

AMS 2249

Chemical Check Analysis Limits, Titanium and Titanium Alloys

AMS 2631

Ultrasonic Inspection--Titanium and Titanium Alloy Bar and Billet

E8/E8M-24

Standard Test Methods for Tension Testing of Metallic Materials

E29-22

Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

AMS 2630

Inspection, Ultrasonic Product Over 0.5 Inch (12.7 mm) Thick

E2626-08

Standard Guide for Spectrometric Analysis of Reactive and Refractory Metals