ASTM F1412-01 - 10.4.2001
 
1. Scope

1.1 This specification covers requirements for nonpressure polyolefin pipe and fittings for corrosive waste drainage systems.

1.2 This specification is a companion to the Canadian Standard, CAN/CSA-B181.3.

1.3 Pipe is produced in Schedule 40 and 80 IPS sizes in two polyolefins, polyethylene (PE) and polypropylene (PP).

1.4 The interchangeability of pipe and fittings made by different manufacturers is not addressed in this specification. Transition fittings for joining pipe and fittings of different manufacturers is provided for in this specification.

1.5 Pipe and fittings are joined by the heat fusion method or by using mechanical joints recommended by the manufacturer.

1.6 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are given for information only.

1.7 The following safety hazards caveat pertains only to the test method, Section 8, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

D2321-20

Standard Practice for Underground Installation of Thermoplastic Pipe for Sewers and Other Gravity-Flow Applications

 Uniform Plumbing Code Available from International Association of Plumbing and Mechanical Officials, 5001 E. Philadelphia St., Ontario, CA 91761, http://www.iapmo.org.

MIL-STD-129

Marking for Shipment and Storage

D543-21

Standard Practices for Evaluating the Resistance of Plastics to Chemical Reagents

D3311-22

Standard Specification for Drain, Waste, and Vent (DWV) Plastic Fittings Patterns

D2657-07(2023)

Standard Practice for Heat Fusion Joining of Polyolefin Pipe and Fittings

D2444-21

Standard Practice for Determination of the Impact Resistance of Thermoplastic Pipe and Fittings by Means of a Tup (Falling Weight)

D2412-21

Standard Test Method for Determination of External Loading Characteristics of Plastic Pipe by Parallel-Plate Loading

F2620-20ae2

Standard Practice for Heat Fusion Joining of Polyethylene Pipe and Fittings (Includes all amendments and changes 3/17/2022).

F1498-08(2020)

Standard Specification for Taper Pipe Threads 60° for Thermoplastic Pipe and Fittings

F1290-19

Standard Practice for Electrofusion Joining Polyolefin Pipe and Fittings

F412-23

Standard Terminology Relating to Plastic Piping Systems

D4101-24

Standard Classification System and Basis for Specification for Polypropylene Injection and Extrusion Materials

D3350-21

Standard Specification for Polyethylene Plastics Pipe and Fittings Materials

D570-22

Standard Test Method for Water Absorption of Plastics

D618-21

Standard Practice for Conditioning Plastics for Testing

D1600-18

Standard Terminology for Abbreviated Terms Relating to Plastics (Withdrawn 2024)

D2122-22

Standard Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings