1.1 This specification covers requirements and test methods for materials of deformed PE liner intended for the rehabilitation of gravity flow and nonpressure pipelines. This application is for municipal sewage, storm water, industrial process liquids and effluents, conduit, and ducts. This renewal process involves installing a deformed liner into an existing pipeline, conduit, or duct, then reforming the liner with heat and pressure to fit tightly to the bore of the original pipeline, conduit, or duct. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. In referee decisions, inch-pound units shall be used. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
D2122-22 | Standard Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings |
Fed. Std. No. 123 | Marking for Shipment (Civil Agencies) Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098, http://dodssp.daps.dla.mil. |
F1248-96 | Standard Test Method for Determination of Environmental Stress Crack Resistance (ESCR) of Polyethylene Pipe |
F412-23 | Standard Terminology Relating to Plastic Piping Systems |
D3350-21 | Standard Specification for Polyethylene Plastics Pipe and Fittings Materials |
D2837-22 | Standard Test Method for Obtaining Hydrostatic Design Basis for Thermoplastic Pipe Materials or Pressure Design Basis for Thermoplastic Pipe Products |
MIL-STD-129 | Marking for Shipment and Storage |
D2412-21 | Standard Test Method for Determination of External Loading Characteristics of Plastic Pipe by Parallel-Plate Loading |
D1693-21 | Standard Test Method for Environmental Stress-Cracking of Ethylene Plastics |
D1600-18 | Standard Terminology for Abbreviated Terms Relating to Plastics (Withdrawn 2024) |
D790-17 | Standard Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials |
D638-22 | Standard Test Method for Tensile Properties of Plastics |
D618-21 | Standard Practice for Conditioning Plastics for Testing |
|