1.1 This specification covers polyamide (PA) butt fusion fittings for use with polyamide pipe (IPS and ISO) and tubing (CTS). Included are requirements for materials, workmanship, dimensions, marking, sustained pressure, and burst pressure. 1.2 &inch-pound-units; 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
D1598-23 | Standard Test Method for Time-to-Failure of Plastic Pipe Under Constant Internal Pressure |
F2785-21 | Standard Specification for Polyamide 12 Gas Pressure Pipe, Tubing, and Fittings |
F412-23 | Standard Terminology Relating to Plastic Piping Systems |
D6779-23 | Standard Classification System for and Basis of Specification for Polyamide Molding and Extrusion Materials (PA) |
D4066-13(2019) | Standard Classification System for Nylon Injection and Extrusion Materials (PA) |
D2513-20 | Standard Specification for Polyethylene (PE) Gas Pressure Pipe, Tubing, and Fittings |
D1600-18 | Standard Terminology for Abbreviated Terms Relating to Plastics (Withdrawn 2024) |
D1599-18 | Standard Test Method for Resistance to Short-Time Hydraulic Pressure of Plastic Pipe, Tubing, and Fittings |
F2945-18(2023) | Standard Specification for Polyamide 11 Gas Pressure Pipe, Tubing, and Fittings |
D2122-22 | Standard Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings |
|