ASTM B351/B351M-02 - 10.6.2002
 
1. Scope

1.1 This specification covers hot- and cold-finished zirconium and zirconium alloy bars, rod, and wire, other than those required for reforging, including rounds, squares, and shapes.

1.2 One unalloyed grade and three alloy grades for use in nuclear applications are described.

1.3 The products covered include the following sections and sizes:

Bars:
Rounds, squares and hexagons Flats3/8 in. (9.5 mm) and over in diameter or size 1/ 4 to 10 in. (6.4 to 250 mm) incl in width and 1/8 in. (3.2 mm) and over in thicknessA
Rod:
Rounds in coils for subsequent reworking1/4 to 3/4 in. (6.4 to 19 mm) in diameter
Wireless than 3/8 in. (9.5 mm) in diameter or size
AThickness 1/8 in. (3.2 mm) to under 3/16 in. (4.8 m) can be cold-rolled strip as well as bar.

1.4 Unless a single unit is used, for example corrosion mass gain in mg/dm2, the values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore each system must be used independently of the other. SI values cannot be mixed with inch-pound values.

1.5 The following precautionary caveat pertains only to the test method portions of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

B350/B350M-26

Standard Specification for Zirconium and Zirconium Alloy Ingots for Nuclear Application

E8/E8M-25

Standard Test Methods for Tension Testing of Metallic Materials

E21-20

Standard Test Methods for Elevated Temperature Tension Tests of Metallic Materials

G2/G2M-25

Standard Test Method for Corrosion Testing of Products of Zirconium, Hafnium, and Their Alloys in Water at 680 ?F [360 ?C] or in Steam at 750 ?F [400 ?C]

E29-22

Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

E114-20

Standard Practice for Ultrasonic Pulse-Echo Straight-Beam Contact Testing

E214-05

Standard Practice for Immersed Ultrasonic Testing by the Reflection Method Using Pulsed Longitudinal Waves (Withdrawn 2007)