ASTM B353-12 - 1.11.2012
 
Significance and Use

16.1 For the purpose of determining compliance with the specified limits of property requirements, an observed value or a calculated value shall be rounded in accordance with the rounding method of Practice E29.

Test

Rounded Units for Observed
or Calculated Value

 

Chemical composition, tolerance
 (when expressed in decimals)

nearest unit in the last right hand place   of figures of the specified limit

Tensile strength and yield strength

nearest 1000 psi (10 MPa)

Elongation

nearest 1 %


 
1. Scope

1.1 This specification covers seamless and welded wrought zirconium and zirconium-alloy tubes for nuclear application. Nuclear fuel cladding is covered in Specification B811.

1.2 Five grades of reactor grade zirconium and zirconium alloys suitable for nuclear application are described.

1.2.1 The present UNS numbers designated for the five grades are given in Table 1.

TABLE 1 ASTM and UNS Number Designations for Reactor Grade Zirconium and Zirconium Alloys

Grade

UNS Number

Reactor-grade zirconium

R60001

Zirconium-tin alloy

R60802

Zirconium-tin alloy

R60804

Zirconium-niobium alloy

R60901

Zirconium-niobium alloy

R60904


1.3 Unless a single unit is used, for example corrosion mass gain in mg/dm2, the values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore each system must be used independently of the other. SI values cannot be mixed with inch-pound values.

1.4  The following precautionary caveat pertains only to the test method portions of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

E21-20

Standard Test Methods for Elevated Temperature Tension Tests of Metallic Materials

B350/B350M-26

Standard Specification for Zirconium and Zirconium Alloy Ingots for Nuclear Application

G2/G2M-25

Standard Test Method for Corrosion Testing of Products of Zirconium, Hafnium, and Their Alloys in Water at 680 ?F [360 ?C] or in Steam at 750 ?F [400 ?C]

E112-25e1

Standard Test Methods for Determining Average Grain Size (Includes all amendments and changes 9/9/2026).

E29-22

Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

B811-25

Standard Specification for Wrought Zirconium Alloy Seamless Tubes for Nuclear Reactor Fuel Cladding

E8-04

Standard Test Methods for Tension Testing of Metallic Materials