1.1 This specification establishes the requirements for brass plate, sheet, strip, and rolled bar of the following alloys: | Copper AlloyUNS No. | PreviousTrade Name | Nominal Composition | | Copper, % | Zinc, % | | | | | | C21000 | Gilding, 95 % | 95 | 5 | | C22000 | Commerical Bronze, 90 % | 90 | 10 | | C22600 | Jewerly Bronze, 871/2 % | 87.5 | 12.5 | | C23000 | Red Brass, 85 % | 85 | 15 | | C24000 | Low Brass, 80 % | 80 | 20 | | C26000 | Cartridge Brass, 70 % | 70 | 30 | | C26800 | Yellow Brass, 66 % | 66 | 34 | | C27200 | | 63 | 37 | | C28000 | Muntz Metal, 60 % | 60 | 40 |
1.2 The values stated in either inch-pound units or SI units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from two systems may results in nonconformance with the standard. |
E112-25e1 | Standard Test Methods for Determining Average Grain Size (Includes all amendments and changes 9/9/2026). |
E8/E8M-25 | Standard Test Methods for Tension Testing of Metallic Materials |
B846-24 | Standard Terminology for Copper and Copper Alloys |
B601-24 | Standard Classification for Temper Designations for Copper and Copper Alloys—Wrought and Cast |
B248M-22 | Standard Specification for General Requirements for Wrought Copper and Copper-Alloy Plate, Sheet, Strip, and Rolled Bar (Metric) |
B248-22 | Standard Specification for General Requirements for Wrought Copper and Copper-Alloy Plate, Sheet, Strip, and Rolled Bar |
E478-24 | Standard Test Methods for Chemical Analysis of Copper Alloys |
|