ASTM B360-09 - 1.10.2009
 
1. Scope

1.1 This specification establishes the requirements for hard-drawn, seamless capillary tube made from Copper Alloy UNS Nos. C10800, C12000, or C12200.

1.2 This tube is commonly supplied in straight lengths intended for restrictor applications such as metering lines for liquids and gases where close control over smoothness and diameter of the bore is required to insure uniform flow characteristics between tubes.

1.3 Units—The values stated in inch pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

E255-23

Standard Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition

E62-89(1996)

Standard Test Methods for Chemical Analysis of Copper and Copper Alloys (Photometric Methods)

E53-07

Standard Test Method for Determination of Copper in Unalloyed Copper by Gravimetry

E8/E8M-25

Standard Test Methods for Tension Testing of Metallic Materials

B846-24

Standard Terminology for Copper and Copper Alloys

B601-24

Standard Classification for Temper Designations for Copper and Copper Alloys—Wrought and Cast

B251-10

Standard Specification for General Requirements for Wrought Seamless Copper and Copper-Alloy Tube

B577-24

Standard Test Methods for Detection of Cuprous Oxide (Hydrogen Embrittlement Susceptibility) in Copper