ASTM B361-08 - 1.11.2008
 
1. Scope

1.1 This specification covers only factory-made wrought aluminum and aluminum-alloy welding fittings in contrast to field-made fittings. The term “welding fittings” applies to butt-welding or socket-end parts, such as 45° elbows, 180° return bends, 90° short radius elbows, and other types made to the dimensional standards specified by ASME B16.9 and B16.11.

Note 1—Throughout this specification use of the term alloy in the general sense includes aluminum as well as aluminum-alloy.

1.2 For acceptance criteria for inclusion of new aluminum and aluminum alloys in this specification, see Annex A1.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and heal practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

B209-14

Standard Specification for Aluminum and Aluminum-Alloy Sheet and Plate

B210-12

Standard Specification for Aluminum and Aluminum-Alloy Drawn Seamless Tubes

B211-12

Standard Specification for Aluminum and Aluminum-Alloy Rolled or Cold Finished Bar, Rod, and Wire

B221-21

Standard Specification for Aluminum and Aluminum-Alloy Extruded Bars, Rods, Wire, Profiles, and Tubes

B241/B241M-22

Standard Specification for Aluminum and Aluminum-Alloy Seamless Pipe and Seamless Extruded Tube

D3951-18(2023)

Standard Practice for Commercial Packaging

Alloy and Temper Designation Systems for Aluminum Available from Aluminum Association, Inc., 1400 Crystal Drive Suite 430, Arlington, VA 22202, http://www.aluminum.org.

Factory-Made Wrought Butt-Welding Fittings Available from American Society of Mechanical Engineers (ASME), ASME International Headquarters, Three Park Ave., New York, NY 10016-5990, http://www.asme.org.

B16.11

Forged Fittings, Socket-Welding and Threaded

Section VIII

Boiler and Pressure Vessel Code

B247-25

Standard Specification for Aluminum and Aluminum-Alloy Die Forgings, Hand Forgings, and Rolled Ring Forgings

B660-23

Standard Practices for Packaging/Packing of Aluminum and Magnesium Products

B881-25a

Standard Terminology Relating to Aluminum- and Magnesium-Alloy Products (Includes all amendments and changes 1/8/2026).

Section IX

Boiler and Pressure Vessel Code

Fed. Std. No. 123

Marking for Shipment (Civil Agencies) Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098, http://www.dodssp.daps.mil.

Personnel Qualification and Certification in Nondestructive Testing

B234-17(2025)

Standard Specification for Aluminum and Aluminum-Alloy Drawn Seamless Tubes for Surface Condensers, Evaporators, and Heat Exchangers