ASTM B37-08 - 1.5.2008
 
1. Scope

1.1 This specification covers aluminum and aluminum alloys in the form of ingots, bars, rods, cones, nuggets or shot, designated as shown in Table 1, for use in the manufacture of iron and steel.

1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

E29-22

Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

B275-14

Standard Practice for Codification of Certain Zinc, Tin and Lead Die Castings (Withdrawn 2020)

E607-02

Standard Test Method for Atomic Emission Spectrometric Analysis Aluminum Alloys by the Point to Plane Technique Nitrogen Atmosphere

B881-25a

Standard Terminology Relating to Aluminum- and Magnesium-Alloy Products (Includes all amendments and changes 1/8/2026).

E34-11

Standard Test Methods for Chemical Analysis of Aluminum and Aluminum-Base Alloys

D3951-18(2023)

Standard Practice for Commercial Packaging

B660-23

Standard Practices for Packaging/Packing of Aluminum and Magnesium Products

E716-16(2021)e2

Standard Practices for Sampling and Sample Preparation of Aluminum and Aluminum Alloys for Determination of Chemical Composition by Spark Atomic Emission Spectrometry (Includes all amendments and changes 9/7/2022).

E1251-25

Standard Test Method for Analysis of Aluminum and Aluminum Alloys by Spark Atomic Emission Spectrometry