ASTM B371/B371M-06 - 1.10.2006
 
1. Scope

1.1 This specification establishes the requirements for copper-zinc-silicon alloy rod produced in Copper Alloy UNS Nos. C69300, C69400, C69430, C69700, and C69710.

1.1.1 If the purchaser does not specify the alloy to be supplied, product is permitted to be furnished in any of the alloys named in 1.1.

1.2 Units - Values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

The following safety hazard caveat pertains only to the test methods described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use. (Warning-Mercury is a definite health hazard in use and disposal.)

 
2. Referenced Documents

E478-24

Standard Test Methods for Chemical Analysis of Copper Alloys

B154-16(2022)

Standard Test Method for Mercurous Nitrate Test for Copper Alloys

E62-89(1996)

Standard Test Methods for Chemical Analysis of Copper and Copper Alloys (Photometric Methods)

E54-80(1996)

Standard Test Methods for Chemical Analysis of Special Brasses and Bronzes (Withdrawn 2002)

E8/E8M-25

Standard Test Methods for Tension Testing of Metallic Materials

B858-06(2024)

Standard Test Method for Ammonia Vapor Test for Determining Susceptibility to Stress Corrosion Cracking in Copper Alloys

B249/B249M-23

Standard Specification for General Requirements for Wrought Copper and Copper-Alloy Rod, Bar, Shapes and Forgings