ASTM F1139-88(1998) - 10.4.1998
 
1. Scope

1.1 This specification provides the minimum requirements for the design, fabrication, pressure rating, marking, and testing of steam traps and drains.

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 The following safety hazards caveat pertains only to the test method portion of this specification. This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

B16.1

Cast Iron Pipe Flanges and Flanged Fittings

ASME Boiler and Pressure Vessel Code, Section IX, W

elding and Brazing Qualifications

B16.4

Cast-Iron Screwed Fittings

B16.5

Steel Pipe Flanges and Flanged Fittings

B16.11

Forged Steel Fittings Socket-Welding and Threaded

B16.15

Cast Bronze Screwed Fittings

B16.18

Cast Bronze Solder-Joint Pressure Fittings

B16.22

Wrought Copper and Bronze Solder-Joint Pressure Fittings

B16.24

Bronze Flanges and Flanged Fittings

B16.34

Steel Valves, Flanged and Buttweld Ends

B31.1

Power Piping

SP-25

Standard Marking System for Valves, Fittings, Flanges, and Unions

SP-51

150 lb Corrosion Resisting Cast Flanges and Flanged Fittings

ANSI/ASME PTC?39.1

Condensate Removal Devices for Steam Systems

ASME Boiler and Pressure Vessel Code, Section VIII

Division I, Pressure Vessels

B16.3

Malleable-Iron Screwed Fittings