ASTM F1173-01 - 10.12.2001
 
1. Scope

1.1 This specification covers reinforced thermosetting resin pipe systems with nominal pipe sizes (NPS) 1 through 48 in. (25 through 1200 mm) which are to be used for all fluids approved by the authority having jurisdiction in marine piping systems.

1.2 Values stated in inch-pound are to be regarded as the standard. Values given in parentheses are for information only.

1.3 The dimensionless designator NPS has been substituted for traditional terms as "nominal diameter," "size," and "nominal size."

1.4 The following safety hazards caveat pertains to the test methods which are included in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

D2310-06

Standard Classification for Machine-Made ""Fiberglass"" (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe

D2105-01(2019)

Standard Test Method for Longitudinal Tensile Properties of “Fiberglass” (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe and Tube

D1599-18

Standard Test Method for Resistance to Short-Time Hydraulic Pressure of Plastic Pipe, Tubing, and Fittings

D1598-23

Standard Test Method for Time-to-Failure of Plastic Pipe Under Constant Internal Pressure

D883-24

Standard Terminology Relating to Plastics

D2584-18

Standard Test Method for Ignition Loss of Cured Reinforced Resins

E1529-22

Standard Test Methods for Determining Effects of Large Hydrocarbon Pool Fires on Structural Members and Assemblies

D5686-95

Standard Specification for ""Fiberglass"" (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe and Pipe Fittings, Adhesive Bonded Joint Type Epoxy Resin, for Condensate Return Lines (Withdrawn 2002)

D5028-17

Standard Test Method for Curing Properties of Pultrusion Resins by Thermal Analysis

D3567-17(2022)

Standard Practice for Determining Dimensions of “Fiberglass” (Glass-Fiber-Reinforced Thermosetting Resin) Pipe and Fittings

D2992-22

Standard Practice for Obtaining Hydrostatic or Pressure Design Basis for “Fiberglass” (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe and Fittings

F412-23

Standard Terminology Relating to Plastic Piping Systems

D2924-24

Standard Test Method for External Pressure Resistance of “Fiberglass” (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe