ASTM A392-11a(2022) - 1.11.2022
 
1. Scope

1.1?This specification covers zinc-coated steel chain-link fence fabric, zinc coated either before or after weaving.

1.2?The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

 
2. Referenced Documents

A90/A90M-21

Standard Test Method for Weight [Mass] of Coating on Iron and Steel Articles with Zinc or Zinc-Alloy Coatings

MIL-STD 163

Steel Mill Products, Preparation for Shipment and Storage

Fed. Std. No. 123

Marking for Shipments (Civil Agencies) Available from Standardization Documents Order Desk, Bldg. 4 Section D, 700 Robbins Ave., Philadelphia, PA 19111-5094, Attn: NPODS.

B6-23

Standard Specification for Zinc

A817-12(2017)

Standard Specification for Metallic-Coated Steel Wire for Chain-Link Fence Fabric and Marcelled Tension Wire

A370-23

Standard Test Methods and Definitions for Mechanical Testing of Steel Products

A700-14(2019)

Standard Guide for Packaging, Marking, and Loading Methods for Steel Products for Shipment