ASTM B302-02 - 10.10.2002
 
1. Scope

1.1 This specification establishes requirements for threadless, seamless, deoxidized copper pipe (TP) in straight lengths, in all nominal or standard pipe sizes, for piping systems that are assembled with brazed-joint pipe fittings. The pipe shall be produced from either of coppers UNS Nos. C10300 or C12200.

1.2 The values stated in inch-pound units are the standard. The values given in parentheses are provided for information only.

1.3 The following safety hazard caveat pertains only to the test methods described Section 16 of this specification:This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to its use.

 
2. Referenced Documents

E62-89(1996)

Standard Test Methods for Chemical Analysis of Copper and Copper Alloys (Photometric Methods)

E53-07

Standard Test Method for Determination of Copper in Unalloyed Copper by Gravimetry

B577-24

Standard Test Methods for Detection of Cuprous Oxide (Hydrogen Embrittlement Susceptibility) in Copper

E243-24

Standard Practice for Electromagnetic (Eddy Current) Examination of Copper and Copper-Alloy Tubes

E255-23

Standard Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition

B846-24

Standard Terminology for Copper and Copper Alloys

B950-26

Standard Guide for Editorial Procedures and Form of Product Specifications for Copper and Copper Alloys

E8-04

Standard Test Methods for Tension Testing of Metallic Materials

B601-24

Standard Classification for Temper Designations for Copper and Copper Alloys—Wrought and Cast

E29-22

Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

E18-25

Standard Test Methods for Rockwell Hardness of Metallic Materials