ASTM B574-99a - 10.10.1999
 
1. Scope

1.1 This specification covers rod of low-carbon nickel-molybdenum-chromium alloys (UNS N10276, N06022, and N06455)*, low-carbon nickel-chromium-molybdenum alloy (UNS N06059), and low-carbon nickel-chromium-molybdenum-tungsten (UNS N06686) as shown in Table 1, for use in general corrosive service.

1.2 The following products are covered under this specification:

1.2.1 Rods 5/16 to 3/4 in. (7.94 to 19.05 mm), exclusive, in diameter, hot or cold finished, solution annealed and pickled, or mechanically descaled.

1.2.2 Rods 3/4 to 3 1/2 in. (19.05 to 88.9 mm), inclusive, in diameter, hot or cold finished, solution annealed, ground or turned.

1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

 
2. Referenced Documents

E1473-22

Standard Test Methods for Chemical Analysis of Nickel, Cobalt, and High-Temperature Alloys

E55-23

Standard Practice for Sampling Wrought Nonferrous Metals and Alloys for Determination of Chemical Composition

B880-24

Standard Specification for General Requirements for Chemical Check Analysis Limits for Nickel, Nickel Alloys and Cobalt Alloys

E527-23

Standard Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)

E8-04

Standard Test Methods for Tension Testing of Metallic Materials

E29-22

Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications