ASTM B581-97 - 10.10.1997
 
1. Scope

1.1 This specification covers rod of Ni-Cr-Fe-Mo-Cu alloys (UNS N06007, N06975, N06985, and N06030)* as shown in Table 1, for use in general corrosive service.

1.2 The following products are covered under this specification:

1.2.1 Rods 5/16 to 3/4 in. (7.94 to 19.05 mm) excl in diameter, hot- or cold-finished, solution annealed and pickled or mechanically descaled.

1.2.2 Rods 3/4 to 3 1/2 in. (19.05 to 88.9 mm) incl in diameter, hot- or cold-finished, solution annealed, ground or turned.

1.3 The values stated in inch-pound units are to be regarded as the standard.

 
2. Referenced Documents

E55-23

Standard Practice for Sampling Wrought Nonferrous Metals and Alloys for Determination of Chemical Composition

E29-22

Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

E8-04

Standard Test Methods for Tension Testing of Metallic Materials

B880-24

Standard Specification for General Requirements for Chemical Check Analysis Limits for Nickel, Nickel Alloys and Cobalt Alloys

E1473-22

Standard Test Methods for Chemical Analysis of Nickel, Cobalt, and High-Temperature Alloys