ASTM B591-20a - 1.10.2020
 
1. Scope

1.1 This specification establishes the requirements for specified copper-zinc-tin alloys and copper-zinc-tin-iron-nickel alloys plate, sheet, strip, and rolled bar. The alloys and nominal compositions are as follows:

Copper Alloy
UNS No.

Copper,
%

Tin,
%

Zinc,
%

Phos.,
%

Iron,
%

Nickel,
%

 

 

 

 

 

 

 

C40500

95

1

4

 

 

 

C40810

95.5

2.0

2.2

0.03

0.1

0.15

C40850

95.5

3.0

1.3

0.1

0.1

0.1

C40860

94.8

2.0

3

0.03

0.03

0.1

C41100

91

0.5

8.5

 

 

 

C41300

91

1

8

 

 

 

C41500

91

2

7

 

 

 

C42200

87

1

12

 

 

 

C42500

88

2

10

 

 

 

C42520

89.8

2.0

8

0.1

0.1

0.1

C43000

85

2

13

 

 

 

C43400

85

0.7

14.3

 

 

 

1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.2.1 Exception—Average grain size in Table 3 is stated in SI units.

1.3 The following safety hazard caveat pertains only to the test method(s) described in this specification:

1.3.1 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

 
2. Referenced Documents

E112-13(2021)

Standard Test Methods for Determining Average Grain Size

E18-22

Standard Test Methods for Rockwell Hardness of Metallic Materials

B248-22

Standard Specification for General Requirements for Wrought Copper and Copper-Alloy Plate, Sheet, Strip, and Rolled Bar

E62-89(1996)

Standard Test Methods for Chemical Analysis of Copper and Copper Alloys (Photometric Methods)

E478-08(2017)

Standard Test Methods for Chemical Analysis of Copper Alloys

B601-18a

Standard Classification for Temper Designations for Copper and Copper Alloys´Wrought and Cast (Includes all amendments and changes 10/24/2018).

B846-19a

Standard Terminology for Copper and Copper Alloys (Includes all amendments and changes 8/8/2019).

E8/E8M-24

Standard Test Methods for Tension Testing of Metallic Materials