ASTM B658/B658M-05 - 1.11.2005
 
1. Scope

1.1 This specification covers three grades of seamless and welded zirconium pipe.

1.2 Unless a single unit is used, for example corrosion mass gain in mg/dm2, the values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore each system must be used independently of the other. SI values cannot be mixed with inch-pound values.

The following precautionary caveat pertains only to the test methods portions of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

B614-26

Standard Practice for Descaling and Cleaning Zirconium and Zirconium Alloy Surfaces

E2626-25

Standard Guide for Spectrometric Analysis of Reactive and Refractory Metals

ASME

Boiler and Pressure Vessel Code, Section IX

E8/E8M-25

Standard Test Methods for Tension Testing of Metallic Materials

Boiler and Pressure Vessel Code, Section VIII Available from American Society of Mechanical Engineers (ASME), ASME International Headquarters, Three Park Ave., New York, NY 10016-5990, http://www.asme.org.

Stainless Steel Pipe Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org.

E29-22

Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications