1.1 This specification establishes the requirements of copper, copper alloy, copper-clad bronze (CCB), copper-clad stainless steel (CCS), and copper-clad alloy steel (CAS) materials, sheet, and strip, in various thicknesses, for use as electrostatic or electromagnetic shielding for insulated power, control, instrumentation, and communication cables. Note 1—See Specification B 736, for related standards for aluminum-based shielding materials. 1.2 The products covered are the following: | Copper or Copper Alloy UNS No. | Type of Products | | | C11000 | copper | | C19400 | copper-iron alloy | | C22000 | copper-zinc alloy (commercial bronze) | | C23000 | copper-zinc alloy (red brass) | | C66400 | copper-zinc-iron-cobalt alloy | | C66410 | copper-zinc-iron alloy | | C66430 | copper-zinc-iron-tin alloy | | C71000 | cupro-nickel 20 % | | ... | copper-clad bronze (CCB) | | ... | copper-clad stainless steel (CCS) | | ... | copper-clad alloy steel (CAS) |
1.3 The values stated in inch-pound units are the standard, except for temperature and grain size which are given in SI units. Values in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
E112-25e1 | Standard Test Methods for Determining Average Grain Size (Includes all amendments and changes 9/9/2026). |
B248-22 | Standard Specification for General Requirements for Wrought Copper and Copper-Alloy Plate, Sheet, Strip, and Rolled Bar |
E478-24 | Standard Test Methods for Chemical Analysis of Copper Alloys |
ISO 3110/2 | Determination of Aluminum; Flame Atomic Absorption Spectrometric Method (TC/26 Ref. No. N698 E/F) Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org. |
E75-76(1996) | Standard Test Methods for Chemical Analysis of Copper-Nickel and Copper-Nickel-Zinc Alloys |
B601-24 | Standard Classification for Temper Designations for Copper and Copper Alloys—Wrought and Cast |
B736-00 | Standard Specification for Aluminum, Aluminum Alloy and Aluminum-Clad Steel Cable Shielding Stock |
B846-24 | Standard Terminology for Copper and Copper Alloys |
E3-26 | Standard Guide for Preparation of Metallographic Specimens |
E8-04 | Standard Test Methods for Tension Testing of Metallic Materials |
E54-80(1996) | Standard Test Methods for Chemical Analysis of Special Brasses and Bronzes (Withdrawn 2002) |
A505-16(2021)e1 | Standard Specification for Steel, Sheet and Strip, Alloy, Hot-Rolled and Cold-Rolled, General Requirements for (Includes all amendments and changes 3/18/2026). |
B152/B152M-24 | Standard Specification for Copper Sheet, Strip, Plate, and Rolled Bar |
B193-25 | Standard Test Method for Resistivity of Electrical Conductor Materials |
E62-89(1996) | Standard Test Methods for Chemical Analysis of Copper and Copper Alloys (Photometric Methods) |
A176-99 | Standard Specification for Stainless and Heat-Resisting Chromium Steel Plate, Sheet, and Strip |
E255-23 | Standard Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition |
|