ASTM B944-22 - 1.10.2022
 
1. Scope

1.1?This specification establishes the requirements for copper-beryllium alloy UNS No. C17510 welded tube in straight lengths.

1.2?UnitsThe values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3?The following safety hazard caveat pertains only to the test method(s) described in this specification.

1.3.1?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

 
2. Referenced Documents

E29-22

Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

E18-22

Standard Test Methods for Rockwell Hardness of Metallic Materials

B194-22

Standard Specification for Copper-Beryllium Alloy Plate, Sheet, Strip, and Rolled Bar

B153-22

Standard Test Method for Expansion (Pin Test) of Copper and Copper-Alloy Pipe and Tubing

E8/E8M-24

Standard Test Methods for Tension Testing of Metallic Materials

E255-23

Standard Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition

E243-18

Standard Practice for Electromagnetic (Eddy Current) Examination of Copper and Copper-Alloy Tubes

B601-18a

Standard Classification for Temper Designations for Copper and Copper Alloys´Wrought and Cast (Includes all amendments and changes 10/24/2018).

B846-19a

Standard Terminology for Copper and Copper Alloys (Includes all amendments and changes 8/8/2019).

E1004-23

Standard Test Method for Determining Electrical Conductivity Using the Electromagnetic (Eddy Current) Method