ASTM B98/B98M-13 - 1.10.2013
 
1. Scope

1.1 This specification establishes requirements for copper-silicon rod, bar, and shapes for UNS Copper Alloys C65100, C65500, and C66100.

Note 1—Material for hot forging is covered by Specification B124/B124M.
Note 2—For ASME Boiler and Pressure Vessel Code applications, see Specification SB-98 in Section II of that code.

1.2 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

 
2. Referenced Documents

B249/B249M-23

Standard Specification for General Requirements for Wrought Copper and Copper-Alloy Rod, Bar, Shapes and Forgings

E8/E8M-25

Standard Test Methods for Tension Testing of Metallic Materials

E18-25

Standard Test Methods for Rockwell Hardness of Metallic Materials

B950-26

Standard Guide for Editorial Procedures and Form of Product Specifications for Copper and Copper Alloys

E478-24

Standard Test Methods for Chemical Analysis of Copper Alloys

B124/B124M-20

Standard Specification for Copper and Copper Alloy Forging Rod, Bar, and Shapes

B601-24

Standard Classification for Temper Designations for Copper and Copper Alloys—Wrought and Cast

E62-89(1996)

Standard Test Methods for Chemical Analysis of Copper and Copper Alloys (Photometric Methods)