ASTM C1007-11 - 15.5.2011
 
1. Scope

1.1 This specification covers the installation and erection requirements for load bearing (transverse and axial) steel studs and related accessories 0.0329 in. (0.836 mm) to 0.1120 in. (2.845 mm) thick.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

 
2. Referenced Documents

C955-24

Standard Specification for Cold-Formed Steel Structural Framing Members

C954-22

Standard Specification for Steel Drill Screws for the Application of Gypsum Panel Products or Metal Plaster Bases to Steel Studs from 0.033 in. (0.84 mm) to 0.112 in. (2.84 mm) in Thickness

AISI COSP

C11-25

Standard Terminology Relating to Gypsum and Related Building Materials and Systems

C1063-26

Standard Specification for Installation of Lathing and Furring to Receive Interior and Exterior Portland Cement-Based Plaster

S100

North American Specification for the Design of Cold-Formed Steel Structural Members - 2007 Edition Available from American Iron and Steel Institute (AISI), 1140 Connecticut Ave., NW, Suite 705, Washington, DC 20036, http://www.steel.org.

MIL-P-21035

Paint, High Zinc Dust Content, Galvanizing Repair Available from Standardization Documents Order Desk, Bldg. 4 Section D, 700 Robbins Ave., Philadelphia, PA 19111-5094, Attn: NPODS.

FF-P-395

Pin, Drive, Guided and Pin Drive, Power Actuated Fasteners for Power Actuated and Hand Actuated Fastening Tools

C841-23

Standard Specification for Installation of Interior Lathing and Furring