ASTM C1140-03 - 10.1.2003
 
1. Scope

1.1 This practice covers procedures for preparing test panels of dry-mix or wet-mix shotcrete and for testing specimens sawed or cored from the panels.

1.2 The values stated in inch-pound units are to be regarded as the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

C78-09

Standard Test Method for Flexural Strength of Concrete (Using Simple Beam with Third-Point Loading)

C138/C138M-24a

Standard Test Method for Density (Unit Weight), Yield, and Air Content (Gravimetric) of Concrete (Includes all amendments and changes 8/6/2024).

C42/C42M-20

Standard Test Method for Obtaining and Testing Drilled Cores and Sawed Beams of Concrete

C995-01

Standard Test Method for Time of Flow of Fiber-Reinforced Concrete Through Inverted Slump Cone (Withdrawn 2008)

C642-21

Standard Test Method for Density, Absorption, and Voids in Hardened Concrete

C513-11

Standard Test Method for Obtaining and Testing Specimens of Hardened Lightweight Insulating Concrete for Compressive Strength

C511-21

Standard Specification for Mixing Rooms, Moist Cabinets, Moist Rooms, and Water Storage Tanks Used in the Testing of Hydraulic Cements and Concretes

C1399-07

Standard Test Method for Obtaining Average Residual-Strength of Fiber-Reinforced Concrete

C1018-97

Standard Test Method for Flexural Toughness and First-Crack Strength of Fiber-Reinforced Concrete (Using Beam With Third-Point Loading) (Withdrawn 2006)

C143/C143M-26b

Standard Test Method for Slump of Concrete (Includes all amendments and changes 8/6/2026).

C457-09

Standard Test Method for Microscopical Determination of Parameters of the Air-Void System in Hardened Concrete

C231-09

Standard Test Method for Air Content of Freshly Mixed Concrete by the Pressure Method

C171-20

Standard Specification for Sheet Materials for Curing Concrete