ASTM C1222-99 - 10.7.1999
 
1. Scope

1.1 This practice covers the technical training and experience of laboratory testing personnel and identifies the minimum technical requirements for laboratory equipment used in testing of hydraulic cement as prescribed by ASTM.

1.2 This practice provides minimum criteria for evaluating the capability of a laboratory to perform chemical or physical tests listed in the various specifications on hydraulic cement (Note 1).

Note 1- Relevant hydraulic cement specifications are C 91, C 150, C 595, C 845, and C 1157.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

C305-20

Standard Practice for Mechanical Mixing of Hydraulic Cement Pastes and Mortars of Plastic Consistency

C451-21

Standard Test Method for Early Stiffening of Hydraulic Cement (Paste Method)

C595-08

Standard Specification for Blended Hydraulic Cements

C845-04

Standard Specification for Expansive Hydraulic Cement

C1157-08

Standard Performance Specification for Hydraulic Cement

C1506-24

Standard Test Method for Water Retention of Hydraulic Cement-Based Mortars and Plasters

E4-24

Standard Practices for Force Calibration and Verification of Testing Machines

ACI?116R

Cement and Concrete Terminology Available from American Concrete Institute (ACI), P.O. Box 9094, Farmington Hills, MI 48333-9094, http://www.aci-int.org.

C114-24

Standard Test Methods for Chemical Analysis of Hydraulic Cement

C115-10

Standard Test Method for Fineness of Portland Cement by the Turbidimeter

C125-26

Standard Terminology Relating to Concrete and Concrete Aggregates

C150-07

Standard Specification for Portland Cement

C185-20

Standard Test Method for Air Content of Hydraulic Cement Mortar

C187-25

Standard Test Method for Amount of Water Required for Normal Consistency of Hydraulic Cement Paste

C191-26

Standard Test Methods for Time of Setting of Hydraulic Cement by Vicat Needle

C91-05

Standard Specification for Masonry Cement

C109/C109M-26a

Standard Test Method for Compressive Strength of Hydraulic Cement Mortars (Using 50 mm [2 in.] Cube Specimens) (Includes all amendments and changes 7/30/2026).

C204-26

Standard Test Methods for Fineness of Hydraulic Cement by Air-Permeability Apparatus

C219-25

Standard Terminology Relating to Hydraulic and Other Inorganic Cements

C230/C230M-23

Standard Specification for Flow Table for Use in Tests of Hydraulic Cement

C266-21

Standard Test Method for Time of Setting of Hydraulic-Cement Paste by Gillmore Needles