ASTM C1349-10 - 1.10.2010
 
1. Scope

1.1 This specification covers the quality requirements for cut sizes of glass clad polycarbonate (GCP) for use in buildings as security, detention, hurricane/cyclic wind-resistant, and blast and ballistic-resistant glazing applications.

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

C162-23

Standard Terminology of Glass and Glass Products

C1036-25

Standard Specification for Flat Glass

E308-22

Standard Practice for Computing the Colors of Objects by Using the CIE System

E1886-19

Standard Test Method for Performance of Exterior Windows, Curtain Walls, Doors, and Impact Protective Systems Impacted by Missile(s) and Exposed to Cyclic Pressure Differentials

E1996-26

Standard Specification for Performance of Exterior Windows, Curtain Walls, Doors, and Impact Protective Systems Impacted by Windborne Debris in Hurricanes

F1233-26

Standard Test Method for Security Glazing Materials And Systems

F1642-12

Standard Test Method for Glazing and Glazing Systems Subject to Airblast Loadings

F1915-05(2025)

Standard Test Methods for Glazing for Detention Facilities

D1044-24

Standard Test Method for Resistance of Transparent Plastics to Surface Abrasion by the Taber Abraser

D3763-23

Standard Test Method for High Speed Puncture Properties of Plastics Using Load and Displacement Sensors

CPSC 16

CFR 1201 Consumer Product Safety Commission Safety Standard for Architectural Glazing Materials Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098

UL 972

Standard for Burglary Resisting Glazing Materials

Z97.1

Safety Glazing Materials Used in Buildings--Safety Performance Specifications and Methods of Tests Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036.

C1048-18

Standard Specification for Heat-Strengthened and Fully Tempered Flat Glass

C1172-24e1

Standard Specification for Laminated Architectural Flat Glass (Includes all amendments and changes 12/4/2025).

C1376-21a

Standard Specification for Pyrolytic and Vacuum Deposition Coatings on Flat Glass (Includes all amendments and changes 11/10/2021).

C1422-99

Standard Specification for Chemically Strengthened Flat Glass

C1503-24

Standard Specification for Silvered Flat Glass Mirror

D256-26

Standard Test Methods for Determining the Izod Pendulum Impact Resistance of Plastics

D543-21

Standard Practices for Evaluating the Resistance of Plastics to Chemical Reagents

D635-22

Standard Test Method for Rate of Burning and/or Extent and Time of Burning of Plastics in a Horizontal Position

D638-22

Standard Test Method for Tensile Properties of Plastics

D648-18

Standard Test Method for Deflection Temperature of Plastics Under Flexural Load in the Edgewise Position

D790-25

Standard Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials

D792-20

Standard Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement

D1003-21

Standard Test Method for Haze and Luminous Transmittance of Transparent Plastics

D1005-95(2024)

Standard Test Method for Measurement of Dry-Film Thickness of Organic Coatings Using Micrometers