ASTM C1490-14(2023) - 1.1.2023
 
Significance and Use

4.1?The process of selection, training and qualification of personnel involved with NDA measurements is one of the quality assurance elements for an overall quality NDA measurement program.

4.2?This guide describes an approach to selection, qualification, and training of personnel that is to be used in conjunction with other NDA Quality Assurance (QA) program elements. The selection, qualification and training processes can vary and this guide provides one such approach.

4.3?The qualification activities described in this guide assume that NDA personnel are already proficient in general facility operations and safety procedures. The training and activities that developed this proficiency are not covered in this guide.

4.4?This guide describes a basic approach and principles for the qualification of NDA professionals and technical specialists and operators. A different approach may be adopted by the management organization based on its particular organization and facility specifics. However, if a variation of the approach of this guide is applied, the resulting selection, training, and qualification programs must meet the requirements of the facility quality assurance program and should provide all the applicable functions of Section 5.

4.5?This guide may be used as an aid in the preparation of a Training Implementation Plan (TIP) for the Transuranic Waste Characterization Program (TWCP).

4.6?This guide describes education and expertise guidance for NDA auditors due to the importance and complexity of proper oversight of NDA activities.

 
1. Scope

1.1?This guide contains good practices for the selection, training, qualification, and professional development of personnel performing analysis, calibration, physical measurements, or data review using nondestructive assay equipment, methods, results, or techniques. The guide also covers NDA personnel involved with NDA equipment setup, selection, diagnosis, troubleshooting, or repair. General guidelines for the selection, training, and qualification of NDA auditors are included as well, but at a lower level of detail due to the variability of the personnels responsibilities performing this functions. Selection, training, and qualification programs based on this guide are intended to provide assurance that NDA personnel are suitably qualified and experienced personnel (SQEP) to perform their jobs competently. This guide presents a series of options but does not recommend a specific course of action.

This standard guide does not address the qualifications per se of an NDA Manager. However, it is expected that the NDA Manager is familiar with NDA techniques, and can make informed decisions on the acceptability of the assay results. If an NDA Manager does not have adequate technical qualifications in the NDA field, they are recommended to undergo training to gain familiarity in this area.

An NDA Manager with no relevant NDA experience should have access to a Senior NDA Professional who will give guidance for all technical decisions such as applicability and limitation of methods, reasonableness of results, needed upgrades and advantageous development investments.

1.2?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

 
2. Referenced Documents

C1493-19

Standard Test Method for Non-Destructive Assay of Nuclear Material in Waste by Passive and Active Neutron Counting Using a Differential Die-Away System

C1221-10(2018)

Standard Test Method for Nondestructive Analysis of Special Nuclear Materials in Homogeneous Solutions by Gamma-Ray Spectrometry

C1030-10(2018)

Standard Test Method for Determination of Plutonium Isotopic Composition by Gamma-Ray Spectrometry

C1133-03

Standard Test Method for Nondestructive Assay of Special Nuclear Material in Low Density Scrap and Waste by Segmented Passive Gamma-Ray Scanning

C1207-10(2018)

Standard Test Method for Nondestructive Assay of Plutonium in Scrap and Waste by Passive Neutron Coincidence Counting

C1458-16

Standard Test Method for Nondestructive Assay of Plutonium, Tritium and 241Am by Calorimetric Assay

C1673-10a(2018)

Standard Terminology of C26.10 Nondestructive Assay Methods (Includes all amendments and changes 5/1/2018).

C1726

Guide for Use of Modeling for Passive Gamma Measurements

C1268-23

Standard Test Method for Quantitative Determination of 241Am in Plutonium by Gamma-Ray Spectrometry

C1316-08(2017)

Standard Test Method for Nondestructive Assay of Nuclear Material in Scrap and Waste by Passive-Active Neutron Counting Using 252Cf Shuffler

C1455-14(2023)

Standard Test Method for Nondestructive Assay of Special Nuclear Material Holdup Using Gamma-Ray Spectroscopic Methods

C1718-10(2019)

Standard Test Method for Nondestructive Assay of Radioactive Material by Tomographic Gamma Scanning

C1500-08(2017)

Standard Test Method for Nondestructive Assay of Plutonium by Passive Neutron Multiplicity Counting

C1592-04

Standard Guide for Nondestructive Assay Measurements

C1514-08(2017)

Standard Test Method for Measurement of 235U Fraction Using Enrichment Meter Principle